FYI: Nissin i40 for Fujifilm: Lo Power settings (below 1/128)
To those who are using an i40 for FUJI, from our recent tests (FUJ.1.002), when you are using M mode from a V6 II to manually control power outputs and set it at a very low power output below 1/128, the flash fires at a very high power, maybe full power? This happens when it was set to below 1/256. This is likely due to the software of the i40 where 1/128 was perhaps already its minimum.
Therefore we recommend not to adjust the power below 1/128 when you are manually adjusting power outputs of the i40 for best performance.
Thanks!
Antonio Lao
Brand Manager
Brand Manager
_____________
To help us better help you, always state the exact firmware version installed on your Cactus device(s), such as: "1.1.013", "NIK.A.001", "v.103", or "A06".
TTL or HSS not working on Cactus V6 II and V6 IIs? Be sure to check hot shoe connectivity by doing the <CAMERA INFO> check.
Feel free to suggest an improvement or share product ideas. Contact us directly at info@cactus-image.com. At Cactus, we listen.