Weird issue with Power Control

NunoAlmeida

Hi, I have a V6 I, and a v6 II, set the camera with the v6 1, and flash, metz 50, with v6 II, when I use the button on the v6 I (on camera) to trigger the flash, power control happens, can easily change the values, it works. When it is the camera firing power stays always the same, it fires, but I can't control power, if I use the button on the V6 it works normally, it's not a problem with the camera.

raychan

The V6 first generation is better to be a receiver when using with V6 II. The V6 as TX doesn't have capability to commend the V6 II RX unit for remote power control. 

NunoAlmeida

Oh but it does, it can control power fine when I use the button on the transmitter, and it also works if I use a cable to trigger the transmitter, if I use the cable but place it on top of the camera... stops working, probably a coldshoe would take care of that.

I returned my unit, so no problem for me anymore, thank you

raychan

Thanks for the feedback.