› ›

Wheel an release button in a bad place.

PlanfotoPlanfoto
in V6 II Suggestions
When the tranceiver is on the camera, your forehead will hit the wheel, while looking in the viewfinder and change settings unintendedly. Move it on to the left side. When pressing the menu buttons, it is natural to "hold against" at the front with you rindex finger. Then you unintendedly release the flash. Move the button to the top side. Thank you very much.

Comments

  • PlanfotoPlanfoto
    ... and the RX/TX switch, whit the "OFF" position in the centre is not great. If you push it tu turn it off, it can easily end up in the opposite mode instead of OFF. The switch should be altered ofr perhaps two keys: one for RX/TX and one for ON/OFF :smile: -)
  • Class AClass A
    Planfoto said:

    When the tranceiver is on the camera, your forehead will hit the wheel, while looking in the viewfinder and change settings unintendedly.

    Do you know that you can "lock" the wheel?

    Have a look into the manual and you'll find a way to prevent your forehead from making undesired changes. Unlocking the wheel before making intentional changes with your fingers is a very quick operation and the trigger will lock itself after a short grace period.

  • AntonioAntonio
    I hope the the Dial Lock is sufficient in addressing the issues you reported @Planfoto

    As for the Mode Switch, we did it that way to save parts and more importantly it is simpler to operate; one less switch to care about.

    Thanks!
    Antonio Lao
    Brand Manager
    _____________

    To help us better help you, always state the exact firmware version installed on your Cactus device(s), such as: "1.1.013", "NIK.A.001", "v.103", or "A06".

    TTL or HSS not working on Cactus V6 II and V6 IIs? Be sure to check hot shoe connectivity by doing the <CAMERA INFO> check.

    Feel free to suggest an improvement or share product ideas. Contact us directly at info@cactus-image.com.  At Cactus, we listen. 
Sign In or Register to comment.