Setup Question

I just received 3 V6's.
Going to shoot with a Fuji X-T1 and two Nikon SB-700.
This may seem like a dumb question, but , do I set the transmitter to the SB-700 profile?
I did update the firmware in all 3 units.

Any other tips are appreciated. I have never used my flashes in manual mode. I will have a learning curve.


  • Hello Bill
    To enable wireless control of SB-700 through the V6 Rx units, please mount the V6 on the SB-700, select SB-700 profile on both V6 Rx units and set both two SB-700 in TTL mode.

    The another V6 Tx unit mounts to the camera's hot shoe. All the V6 units are on the same channel and assign Rx unit into Group A, B, C or D and that would allow you to choose which group to fire from the Tx unit.

    Be sure to turn on SB-700 in TTL mode, then V6 in sequence. So the V6 can initialize correctly with Nikon flash.

    I hope this is helpful. Should you have any question, please feel free to contact me.

Sign In or Register to comment.